Toyota Corolla: Essential information / Emergency flashers
The emergency flashers are used to warn other drivers when the vehicle has to
be stopped on the road due to a breakdown, etc.
Operating instructions
Press the switch.
All the turn signal lights will flash.
To turn them off, press the switch once again.

■ Emergency flashers
- If the emergency flashers are used for a long time while the engine is not
operating, the battery may discharge.
- If any of the SRS airbags deploy (inflate) or in the event of a strong rear
impact, the emergency flashers will turn on automatically. The emergency flashers
will turn off automatically after operating for approximately 20 minutes. To
manually turn the emergency flashers off, press the switch twice. (The emergency
flashers may not turn on automatically depending on the force of the impact
and conditions of the collision.)
Only in an emergency, such as if it becomes impossible to stop the vehicle in
the normal way, stop the vehicle using the following procedure:
Stopping the vehicle
1 Steadily step on the brake pedal with both feet and firmly depress it...
Other information:
1 With the headlights on, push the lever away from you to turn on the high beams.
Pull the lever toward you to the center position to turn the high beams off.
2 Pull the lever toward you and release it to flash the high beams once.
You can flash the high beams with the headlights on or off...
Check if the treadwear indicators are showing on the tires. Also check the tires
for uneven wear, such as excessive wear on one side of the tread.
Check the spare tire condition and pressure if not rotated.
A - New tread
B - Worn tread
C - Treadwear indicator
The location of treadwear indicators is shown by a “TWI” or “”
mark, etc...