Toyota Corolla: Maintenance / Emission inspection and maintenance (I/M) programs
Some states have vehicle emission inspection programs which include OBD (On Board Diagnostics) checks. The OBD system monitors the operation of the emission control system.
If the malfunction indicator lamp comes on
The OBD system determines that a problem exists somewhere in the emission control system. Your vehicle may not pass the I/M test and may need to be repaired. Contact your Toyota dealer to service the vehicle.
Your vehicle may not pass the I/M test in the following situations:
- When the battery is disconnected or discharged
Readiness codes that are set during ordinary driving are erased. Also, depending on your driving habits, the readiness codes may not be completely set.
- When the fuel tank cap is loose
The malfunction indicator lamp comes on indicating a temporary malfunction and your vehicle may not pass the I/M test.
When the malfunction indicator lamp still remains on after several driving trips
The error code in the OBD system will not be cleared unless the vehicle is driven 40 or more times.
If your vehicle does not pass the I/M test
Contact your Toyota dealer to prepare the vehicle for re-testing.
General maintenance
Listed below are the general maintenance items that should be performed at the
intervals specified in the “Owner’s Warranty Information Booklet” or “Owner’s Manual
Supplement/Scheduled Maintenance Guide”...
Other information:
Toyota Corolla 2019-2026 Owners Manual: Vehicle information display
■ Drive information Displays drive information such as the following: A - Drive information type B - Drive information items Displays the following depending on which drive information type and drive information items were selected in . After start Distance: Displays the distance driven since engine start Elapsed time: Displays the elapsed time since engine start Average vehicle speed:..
Toyota Corolla 2019-2026 Owners Manual: Replacing a flat tire
1 Chock the tires. 2 Vehicles with a steel wheel: Remove the wheel ornament (if equipped) using the wrench. Insert the wrench into the notch A on the wheel cap. To protect the wheel ornament, place a rag between the wrench and the wheel ornament. 3 Slightly loosen the wheel nuts (one turn). 4 Turn the tire jack portion A by hand until the center of the recessed portion of the jack is in con..
Categories
- Manuals Home
- 12th Generation Corolla Owners Manual
- Sound settings
- Alarm
- Air conditioning controls
- New on site
- Most important about car
Operating HomeLink
Press the appropriate Home- Link® button. The HomeLink® indicator light should turn on.
The status of the opening and closing of a garage door is shown by the indicators.
